Read Full Story — Construction
A firm running industrial facility and factory projects had begun pushing the limits of its traditional 2D drawing-based design process as project complexity increased.
When drawings from different disciplines (mechanical, electrical, structural) were prepared separately, clashes were usually only discovered on the construction site — the point where changes are most costly. Moving to BIM was technically the right decision; but the design team's why change something that has worked for years reaction, and the field teams' anxiety about learning new software, made the transition difficult from the start.
A three-phase transition overcame resistance through evidence:
Rather than transforming the whole firm at once, a volunteer team piloted BIM on a single mid-sized project; this kept risk limited and created a natural proof point.
Three clashes caught early in the pilot project were presented to the whole firm together with a calculation of how costly these errors would have been had they been caught on site instead; this turned an abstract technology promise into a concrete gain.
Experienced drafters were shown that their technical knowledge remained valuable within the BIM environment too — that what needed to be learned was a new tool, not a new profession.
After eleven months, the majority of new projects were being run with BIM. The early clash detection seen in the pilot project also led to a marked reduction in field revision costs.
Resistance to technological change usually stems not from the technology itself but from an unanswered what does this mean for me. A small pilot and a concrete example of gain persuade even the most reluctant teams far more effectively than abstract presentations.
Share this content:
Comments (0)
No comments yet. Be the first to write one.